In a stable environment where there are relatively few changes being made you could go several hours, if not days, without having any I/O to the boot device (assuming your logs are on a separate device). However, the reality is that in most cases it will write far less. In a worst case scenario, ESXi has the potential to write its configuration at a rate of once every 10 minutes. Trying to narrow down a specific number of times the ESXi host will write to the boot device is difficult as there are many factors to consider. Like the on demand backups initiated by ‘hostd’, the VMware HA initiated backups are also throttled so they occur no more than once every 10 minutes. VMware HA will also trigger a backup when HA is (re)configured and anytime there is a change in the cluster membership. If you make multiple changes in a short 20 minute window causing ‘ hostd’ to reach it’s limit of 6, the ‘ hostd’ will stop performing backups and the outstanding configuration changes will then get saved with the next hourly backup.Ĥ. One thing to note about the ‘ hostd’ initiated backups is that in an effort to avoid performing too many backups in short succession the ‘ hostd’ backups are throttled to no more than 6 backups an hour.
#How to update esxi usb boot disk password
The ESXI ‘ hostd’ will initiate an immediate backup following certain types of configuration changes, such as changing the root password or changing settings on the management network. If there are no changes there is no backup.ģ. Again, a backup only occurs when changes are found. This script first checks for any outstanding changes and if detected will invoke the /sbin/backup.sh script to perform a backup. Once an hour the /sbin/auto-backup.sh scripts is invoked from the root user’s crontab. If there are no changes there is no backup.Ģ.
Note that a backup only occurs when changes are found. This backup ensures any outstanding host configuration changes will be flushed to the disk and available on reboot.
Each time a host shutdown is initiated the /sbin/backup.sh script is invoked from the /etc/inittab. Outside of the initial installation, when the binaries are first laid out on the boot device, there are four scenarios where the ESXi configuration will be saved to the boot device:ġ. As such I did some research and here’s a bit more detail on how frequently ESXi writes to the boot device. This generated a lot of questions and it quickly became evident that people wanted to understand more about how a running ESXi hosts interacts with the boot device, especially when booting off of USB/SD. Technical Marketing Manager, VMwareĪ couple weeks back I wrote about booting from USB/SD and made the comment that ESXi will routinely save the host configuration to the boot device once every 10 minutes.
0 kommentar(er)
